Nov 9, 2018 · I'm attaching an LTspice file that simulates a crystal oscillator with resonant frequency 1MHz, and it works fine. But if I change L1 from 2.5 H to 9.8 mH to simulate a …

Dec 23, 2019 · I have been trying to simulate a VCO for a CB radio on LTspice, but cannot get it to run. The ac analysis give me a peak at about 3.5 MHz but cannot get anything from the …

Jun 13, 2019 · Hello, I need to simulate a 3 phase star-delta (Yd11) transformer in LTspice. Any idea of how can I proceed? Thanking in anticipation.

Dec 31, 2022 · Does anybody know how to simulate high frequency signal and circuit in proteus? For several hundreds KHz it works well but when signal are in MHz range the circuit does not …

Jul 28, 2021 · I would like to simulate a small signal RF amplifier on VHF. Can LTSpice simulate RF and if so can anyone point me to a tutorial that shows the proper set-up for LTSpice? …

May 22, 2019 · But how can i simulate those two signals on one same line ? A signal line cannot be at two different voltages at the same time. My circuit designs should be regarded as …

Nov 23, 2021 · Hi, Do you know how to make the attached LTspice of a d type flip flop work? The output is just stuck high Woops sorry...it is workign, pse delete this post...

Jun 15, 2017 · Hi.. I am trying to simulate a Totem pole Boost PFC circuit using GaN switches on LTspice. I am unable to achieve the DC output and the circuit is also not boosting up the input …

Dec 5, 2013 · hi, how do i model a 12V 1.2A motor in LT spice? i am guessing i have to use an inductor as the motor is a inductive load, but how do i work out what size inductor and do i …

Apr 22, 2006 · Trying to use orcad to simulate some circuits and i am struggling to get anything to work. Ive done some searching on here and found alot of questions relating to orcad.